Install The Powerglide Plus Wiring; Install The Autoboom Node - Raven AutoBoom Installation Manual

Apache 2004 & older

Hide thumbs Also See for AutoBoom:

Table of Contents

Chapter 4

Install the PowerGlide Plus Wiring

Wiring Connections

For wiring connections made outside the cab, apply dielectric silicone grease (P/N 222-0000-006) generously

on both the male and female ends of the connectors. Application of the grease will prevent corrosion to the

pins and wires.

PowerGlide Plus AutoBoom Node Installed

FIGURE 12.

Mount the AutoBoom node (P/N 063-0130-010) to the machine's cross beam within close proximity to the

AutoBoom valve.

Insert the large, rectangular node connectors on the AutoBoom harness cable (P/N 115-0230-045) into the

correct ports of the AutoBoom valve.

Tighten the bolts on the node connectors to secure the connections.

CAUTION

Always connect the power cable as the last

step in the wiring process and verify that the

power leads are connected with the correct

polarity. Reversing power leads can cause

severe damage to the equipment.

Apache (2004 & Older) AutoBoom Installation Manual

Table of Contents