Install The Pressure And Tank Hoses - Raven AutoBoom Installation Manual

INSTALL THE PRESSURE AND TANK HOSES

FIGURE 2. Pressure Hose Installed on Machine's Hydraulic Valve
1. Locate and remove the plug from port P2 of the machine's hydraulic valve.
2. Install a -8 ORFS (M) to -8 JIC (M) straight adapter fitting (P/N 333-0012-168) in the open port of the machine's
hydraulic valve.
3. Install the straight end of the supplied hydraulic hose (P/N 214-1001-136) on the fitting installed in the
machine's pressure port.
FIGURE 3. Pressure Hose Installed on AutoBoom Valve
4. Connect the 90° end of the installed hydraulic hose to the fitting installed in Port P of the AutoBoom valve.
P/N 016-0230-124 Rev. A
WARNING
Hydraulic are under pressure. Care should always
be taken with a system that has been pressurized.
When disconnecting or purging hydraulic hoses,
be aware that the machine's system may be
extremely hot and under high pressure.
HYDRAULIC SYSTEM INSTALLATION
Installed Hydraulic
Hose
(P/N 214-1001-136)
in Machine's Pressure
Port
Installed Hydraulic
Hose
(P/N 214-1001-136) in
Port P of AutoBoom
Valve
15