Install The Ultraglide Hydraulic System; Install The Fittings On The Autoboom Valve - Raven AutoBoom Installation Manual

Chapter 4

Install the UltraGlide Hydraulic System

Install the Fittings on the AutoBoom Valve

Before mounting the AutoBoom valve on the machine, install the fittings in the appropriate ports of the
AutoBoom valve. This prepares the valve for installation and simplifies the hose connection process later in the
procedure. Refer to the following table to install the fittings.
Fitting - 11/16" ORFS (M) to 3/4" SAE O-Ring (M) 90° Elbow
Fitting - 11/16" ORFS (M) to 9/16" SAE O-Ring (M) Straight Adapter
30 Case IH Patriot, Model Year 2010 & Newer AutoBoom™ Installation Manual
The machine must remain stationary and
switched off, with the booms unfolded and
supported, during installation or maintenance.
When installing AutoBoom hydraulics or
performing diagnostics, maintenance, or routine
service, ensure precautions are taken to
prevent any foreign material from being
introduced into the machine's hydraulic system.
Objects or materials that are able to bypass the
machine's hydraulic filtration system will reduce
performance and possibly cause damage to the
AutoBoom hydraulic valve.
NOTICE
The appearance of the AutoBoom hydraulic
valve may vary slightly from the images
contained in this manual. However, the fittings,
hose connections, and cable connections
remain the same.
Fitting
WARNING
CAUTION
Part Number
333-0012-165
333-0012-084
Port
LF CYL RTN,
RT CYL RTN
LC, RC