Kaba ILCO FDU User Manual page 134

Purpose:
Minimum keycard:
Shortcut:
Expiry:
Factory default expiry:
Parameters:
Notes:
Purpose:
Minimum keycard:
Shortcut:
Expiry:
Factory default expiry:
Parameters:
Notes:
Keycards
D.3 Passage
Puts the lock in Passage mode, in which a keycard is no longer required to open the
door. Passage mode is removed by re-inserting the Passage keycard. Passage mode
capability must be enabled for each specified room number when the FDU is
programmed at the factory (see Chapter 6 – Implementing the System). Typically,
rooms such as Common Areas and meeting rooms are appropriate for the use of
Passage mode.
Rented Guest rooms should not be put in Passage mode.
General Manager Authorization for Staff Common Areas and Restricted Areas
Master Authorization for Guest Common Areas and other rooms.
Swipe authorized keycard, press 4 and 4
From 1 to 2730 nights
1 night
Type (Guest room, Guest Common Area, Staff Common Area, Restricted Area)
For security reasons, when a lock is in passage mode, the lock will not indicate give
any indication that it is set in this state. All valid keycards will provide the same
indications as if the lock was in its regular state.
D.4 Hotel Restart
Used to set or change the Hotel Code when installing the system or if an FDU is
stolen. If a Hotel Restart keycard is swiped in the FDU, a series of menus appears.
Consult the instructions in Section 3.5.9 – Hotel Restart before continuing.
All assigned PINs of the FDU will be cancelled.
General Manager Authorization
Swipe authorized keycard, press 4 and 6
From 1 to 24 hours
24 hours
Hotel Code
Call Kaba Ilco for assistance.
Kaba Ilco Lodging Access Control System
Number of cards
123