Indicator Description - HikRobot CameraLink User Manual

No. Signal
11 IO_OUT1_P
12 IO_OUT1_N
You should refer to the table above and the label attached to the power and I/O cable to
wire the device.

2.2 Indicator Description

The indicator has different status, and please refer to the following table for the details.
No. Indicator Status
1 Very slow flashing red
2 Solid blue
3
Rapid flashing blue
4
Slow flashing blue
Flashing blue and red in
5
alternative
Flashing blue and red in
6
simultaneous
When the indicator is flashing slowly, its unlit interval is about 1 s.
CameraLink Line Scan Camera
I/O Signal Source
Line 4+
Line 4-
Table 2-2 Indicator Status Description
Description
The data transmission exception occurs.
After starting up, the camera shows this status. No
data is transmitting.
The camera is acquiring images in internal trigger
mode.
The camera is acquiring images in external trigger
mode.
The camera firmware is updating.
The camera exception occurs.
User Manual
·
Description
Differential output 1+
Differential output 1-
4