Goldacres Prairie Pro Operator's Manual page 55

e i al n
• Turn the Induction hopper valve on the EZ
control Pressure Delivery station to 'Bypass'.
• Drain the hopper of any remaining liquid using
the hopper drain tap at the bottom of the
hopper.
RINSING OUT THROUGH DRAIN
The hopper can be rinsed and the rinsate emptied
through the hopper drain ball valve rather than
transferred into the main spray tank.
CAUTION: Spray pump should be turned off.
To do this:
1. nsure the fresh water filling supply pump system
is operating.
2. OPEN the hopper rinse valve on the top of the
hopper.
3. OPEN the hopper tank ball valve at the bottom
of the hopper by turning up the yellow handle so
that it is vertical, removing the rinsate from the
hopper.
4. OPEN the hopper drain valve.
5. Once the tank is clean, stop the fresh water
supply to the machine.
6. CLOSE the hopper rinse valve on the top of the
hopper.
7. Turn the hopper tank valve at the bottom of
the hopper OFF by turning the yellow handle
horizontal.
8. Close the hopper drain valve.
9. Raise the hopper to its transport position and
replace the retaining pin in the mechanism.
NOTE:
• Take proper safety precautions to avoid any
contact with rinsate when draining, as it may
contain chemical residue.
• Be mindful of where rinsate is deposited as it may
contain chemical residue.
• This procedure will not rinse the hose from the
bottom of the hopper to the main tank.
Prairie Pro Operator's Manual MY19 - REV 2
tion opper
Hopper Drain Tap -
Photo look up from un-
derneath the hopper
Chapter 8 - Operation - 49