Table of Contents
Advertisement
Fill Flow Meter
3. To do this, press 'PRO' and hold down for 3 seconds. sing the up and down arrows ad ust the number so
that it matches the flow meter calibration figure pulses liter .
4. Press the 'PRO' button once the correct calibration number has been entered. This will take you to the next
screen but will also set the calibration figure that was ust entered. To save the flow meter cal figure, the
'Pro' button must be pressed once. ont press and hold the 'PRO' button to exit from this screen or changes
wont be saved. See step 6 for exiting calibration.
5. When in this screen, the maximum target volume is set. This is used as a uick reset to the tanks maximum
volume. se the up and down arrows to set the re uired maximum tank volume.
6. Once all calibrations have been entered, press and hold 'PRO' for 3 seconds to go back to the fill screen.
shown below, numbers shown here may vary to what is displayed on your screen
. To set the target volume, press 'PRO' once so the target value flashes. se the arrows to ad ust the value.
Press 'PRO' when value is reached.
. Press up and down arrows simultaneously to turn off.
Prairie Pro Operator's Manual MY19 - REV 2
erie
Continued over page
Chapter 12 - Optional Accessories -
Advertisement
Table of Contents
