Table of Contents
Advertisement
will both blink together. Numeric Display will also
show a value (XXXX), which represents the present
value stored in flow meter's memory.
5. Press INCREASE or DECREASE buttons to change
the value shown in Numeric Display to desired value.
6. To complete CALIBRATION for COUNTS (CNT),
press MODE button for 3–5 seconds. CALIBRATE
e i al ran er Flow Meter
(CAL) and COUNTS (CNT) indicators will turn off and
display will show CAL if CALIBRATION was successful.
4. CALIBRATE (CAL) and COUNTS (CNT)
NOTE: If MODE button is pressed for less than 3 sec-
indicators will both blink together. Numeric
onds, CALIBRATION will be aborted and display will
Display will also show a value (XXXX), which
show Err (Error) to indicate the CALIBRATION was not
represents the present value stored in flow
successful. Display will return to CURRENT TOTAL
meter's memory.
(CUR) without making any changes.
5. Press INCREASE or DECREASE buttons to
change the value shown in Numeric Display to
desired value.
6. To complete CALIBRATION for COUNTS (CNT),
press MODE button for 3–5 seconds.
CALIBRATE (CAL) and COUNTS (CNT)
indicators will turn off and display will show CAL
if CALIBRATION was successful.
NOTE: If MODE button is pressed for less than 3
seconds, CALIBRATION will be aborted and display
will show Err (Error) to indicate the CALIBRATION
was not successful. Display will return to CURRENT
TOTAL (CUR) without making any changes.
To purchase parts, please contact our Sales Department at 800-424-9776.
911-729 (4/12, Rev. C)
126 - Chapter 12 - Optional Accessories
FM-1100 & FM-1100i Kits List / Parts Drawing
2
1
1. Press MODE button to turn meter on.
2. Press MODE button again to display CUMULATIVE
TOTAL (CUM).
3. While display is showing CUMULATIVE TOTAL
(CUM), press and hold DECREASE button to display
flow meter's software revision number (e.g. r1.00).
CUMULATIVE TOTAL CANNOT BE RESET - EVEN BY
REMOVING THE BATTERIES.
o
i pla
er
1. Press MODE button to turn meter on.
2. Press MODE button again to display
CUMULATIVE TOTAL (CUM).
3. While display is showing CUMULATIVE TOTAL
(CUM), press and hold DECREASE button to
display flow meter's software revision number
(e.g. r1.00).
NOTE: CUMULATIVE TOTAL CANNOT BE RESET
- EVEN BY REMOVING THE BATTERIES.
4a
3
Reference only
8
o tware e i ion
4b
Prairie Pro Operator's Manual MY19 - REV 2
Advertisement
Table of Contents
