Goldacres Prairie Pro Operator's Manual page 142

ire t
CHANGING THE ORDER IN WHICH
ADDITIONAL PRODUCTS APPEAR ON THE
CONSOLE SCREEN
If more than one injection unit is connected to
the console the order in which they appear as the
2nd and 3rd product on the console screen can
be change to suit the operator using the following
procedure;
NOTE: The console will automatically allocate the
carrier product to the 1st position on the screen
• Momentarily depress the [DATA MENU] key to
bring up the data submenu at the bottom of the
screen. The word 'SERIAL' will be highlighted.
• Momentarily depress the [DATA MENU] key
repeatedly until 'CAN' is highlighted
• Momentarily depress the key repeatedly to move
the curser adjacent to the line 'PRESS ENTER TO
READRESS PROD NODES'
• Depress the [ENTER] key to begin the reboot
process
• The console will now display 'REBOOT NODES
IN SEQNC, PRESS ENTER WHEN DONE'
• Disconnect the logic power to both injection
pumps (the logic power is the smaller of the two
sets of red and white wires leading to each pump.
Disconnect by either uncoupling the plug or
pulling out the 5 amp fuse)
• Wait a few seconds then reconnect the injection
units in the order you wish them to assume
the 2nd and 3rd position on the screen (note:
position 1 will always be taken up by the carrier
product)
• Depress the [ENTER] key again to resume
normal operation
NOTE: If the console displays 'check control node 2
or 3' when reconnecting an injection module at any
stage;
• Momentarily depress the [DATA MENU] key to
bring up the data submenu at the bottom of the
screen. The word 'SERIAL' will be highlighted.
• Momentarily depress the [DATA MENU] key
- Chapter 12 - Optional Accessories
e i al n e tion SCS4400 Programming
repeatedly until 'CAN' is highlighted.
• Momentarily depress the key repeatedly to move
the curser adjacent to the particular product be it
either 2 or 3.
• If the communication link is turned 'off ' the
console will display 'PROD CONTROL NODE 2
OR 3 NOT INSTALLED'.
• At this point momentarily depressing the [CE]
key will turn the communication link between the
console and the injection pump unit either 'on'.
• If properly connected and turned 'on' a PGM and
VER number should be displayed.
• Depress and volume or area key to resume
normal operation.
Prairie Pro Operator's Manual MY19 - REV 2