Setting Up Set A - Christie LW502 User Manual

Installation
2.2 Installing the first projector (Set A)

Setting up Set A

1.
Turn on Set A.
2.
Set the lens position to the upper limit with the VERTICAL adjuster.
• If it is not set to the upper limit, the image of Set B may not
NOTE
superimpose to the image of Set A.
• Run the INSTALLATION setting if necessary as it may change the image
position. (Operating Guide
• HORIZONTAL adjuster is recommended to be set near the center position.
3.
Adjust the image of Set A to fit the screen with the VERTICAL adjuster,
HORIZONTAL adjuster, ZOOM ring and FOCUS ring.
→
Displaying the
Adjust the image position using KEYSTONE and 3D KEYSTONE if necessary.
(Operating Guide
NOTE • Do not adjust ZOOM ring to the widest position, otherwise the image
of Set B may not superimpose to the image of Set A. Fine adjusting the image
position of Set B electrically does not increase its image size. Use the ZOOM
ring to adjust the image size of Set B to slightly larger than Set A.
• KEYSTONE, 3D KEYSTONE, and WARPING functions cannot be used at
the same time. Use an appropriate function.
• If using Simple Stack, go to
( 10 )
(continued on next page)
LW502/LWU502/LX602 User's Manual - Instant Stack Guide
020-001085-02 Rev. 1 (02-2018)
→
picture)
→
EASY MENU
2.3 Installation of the second projector (Set
SETUP menu)
or SETUP menu)
(User's Manual (concise)
B).
8