Installing The First Projector (Set A); Deciding Installation Position; Setting Up Set A - Christie LX501 User Manual

LX501/LX601i/LW401/LW551i/LWU421/LWU501i
Installation

2.2 Installing the first projector (Set A)

Deciding installation position

Decide the position of Set A and its projection angle.
→ Arrangement and
WARNING ►Only for LX601i, LW551i and LWU501i, it is possible to install
the projector for any direction with specified mounting accessories. Consult with
your dealer about such a special installation.
NOTE • Set the tilt angle of Set A to within 9 degrees from the level line.

Setting up Set A

1.
Turn on Set A.
2.
Perform the INSTALLATION setting first if necessary as it may change the
image position.
3.
Adjust the image of Set A to fit the screen with the ZOOM, FOCUS and LENS
SHIFT features.
Adjust the image position using KEYSTONE and PERFECT FIT if necessary.
(Operating Guide
• KEYSTONE cannot be operated when PERFECT FIT is in use.
NOTE
To adjust the image using both KEYSTONE and PERFECT FIT, adjust
KEYSTONE first.
• If you are using Simple Stack, go to
B). ( 8 )
(Set
(continued on next page)
Instant Stack Guide
Adjusting the projector's
(Operating Guide
(Operating Guide
→
EASY MENU
(User's Manual (concise)
elevator)
→ SETUP menu )
→ Adjusting the lens)
or
SETUP menu)
2.3 Installation of the second projector
6
020-000489-02 Rev. 1 (06-2012)