Installing The First Projector (Set A); Deciding Installation Position; Setting Up Set A - Christie DWU951 User Manual

Installation

2.2 Installing the first projector (Set A)

Deciding installation position

Decide the position of Set A and its projection angle. (User's Manual (concise)
→ Arrangement and Adjusting the projector's elevator)
WARNING ►It is possible to install the projector for any direction with
specified mounting accessories. Consult with your dealer about such a special
installation.
• Set the tilt angle of Set A to within 5 degrees from the level line.
NOTE

Setting up Set A

1.
Turn on Set A.
2.
Perform the INSTALLATION setting first if necessary as it may change the
image position. (Operating Guide → SETUP menu )
3.
Adjust the image of Set A to fit the screen with the ZOOM, FOCUS and LENS
SHIFT features. (Operating Guide → Adjusting the lens)
Adjust the image position using KEYSTONE and 3D KEYSTONE if necessary.
(Operating Guide → EASY MENU or SETUP menu)
• KEYSTONE, 3D KEYSTONE, BLENDING, or WARPING function
NOTE
cannot be used at the same time. Please use an appropriate function.
• If you are using Simple Stack, go to 2.3 Installation of the second projector
(Set B). ( 8 )
DWU951/DHD951/DWX951/DXG1051 User's Manual - Instant Stack Guide
6
020-000663-02 Rev. 1 (06-2014)