Connecting Projectors; Setting Up Set B - Christie LW502 User Manual

2.3 Installing the second projector (Set B)

Connecting projectors

To use Intellectual Stack, connect an RS-232C cross cable between the CONTROL
port of Set A and Set B.

Setting up Set B

1.
Turn on Set B.
NOTE • After turning on Set B, make sure the image of Set B is not
signifi cantly tilted compared to the image of Set A. If the image is overly tilted,
rotate the elevator feet of Set B to adjust the angle such that the tilt is just
about right.
2.
Reset the adjustment of KEYSTONE and 3D KEYSTONE on Set B.
(Operating Guide
• KEYSTONE, 3D KEYSTONE, and WARPING functions cannot be
NOTE
used at the same time. Use an appropriate function.
• Run the INSTALLATION setting if necessary as it may change the image
(Operating Guide
position.
(continued on next page)
LW502/LWU502/LX602 User's Manual - Instant Stack Guide
020-001085-02 Rev. 1 (02-2018)
→
EASY MENU or
→
SETUP
SETUP menu)
menu)
Installation
11