4.2 Connecting signal cables
There are two methods to input an image to the Sub projector. ( 22, 23 )
- Inputting an image from the MONITOR OUT (HDMI OUT) port on Main to Sub.
- Inputting an image to Sub and Main individually.
Inputting an image from Main to Sub
Using MONITOR OUT port
1.
Connect the MONITOR OUT port on Main to the COMPUTER IN port on Sub
with a computer cable.
2.
Connect the image output device to COMPUTER IN port on Main.
NOTES for Intellectual Stack
• COMPUTER IN can be used as the input
port for the Main projector in Intellectual Stack.
Do not use other ports for image input.
- You can input component signals to
COMPUTER IN.
NOTES for Simple Stack
• COMPUTER IN can be used as the input
port for the projector that is connected with a
computer cable at its MONITOR OUT port. If
you want to use other input ports, input the
image to Sub and Main individually.
(continued on next page)
LW502/LWU502/LX602 User's Manual - Instant Stack Guide
020-001085-02 Rev. 1 (02-2018)
Connecting cables
Main
HDBaseT:
LW502/
LWU502 only
Sub
HDBaseT:
LW502/
LWU502 only
29