Table of Contents
Advertisement
HC 402 EU/MK • Setup Guide (Continued)
Panels and Features
Front Panel Features
HCR 102
INPUT
R
CONFIG
I J
A
B
HCR 102 Front Panel (Above),
Figure 2.
HCT 101 EU and HCT 101 MK Front Panels (Right)
A
Configuration
(Config) connector (USB mini-B), page 11
B
Input selection button and
C
Input signal presence (Signal)
D
HDCP status
LED, page 14
E
Audio input type LEDs
F
Menu button,
G
Enter button, and
H
Navigation (right , left , up
To configure the AV settings using the OSD and front panel buttons:
on page 7)
I
Power LED (HCT 101 EU or HCT 101 MK), power and reset indicator
LED (HCR 102) — This green LED indicates either the power status of
the HCT transmitter or the HCR 102 receiver, or the reset mode of the
receiver. For LED indications, see the table below.
J
Reset button
(HCR 102) — Pressing this recessed button causes
various product settings to be reset to the factory defaults (see
Modes: a Brief Summary
Reset and power LED (
I
HCT 101 EU or MK Transmitter
•
Off — The unit is not powered on.
•
On, lit amber — The unit is powered on
but there is no active signal at that input.
•
On, lit green — The unit is powered on
and there is an active signal at that input.
2
C
1
SIGNAL
1
HDCP
D
LED, page 14
LED, page 14
(LPCM-2Ch and Multi-Ch, page 14
, and down
on page 15).
) indications are as follows:
HCR 102 Receiver
•
Off — The unit is not powered
on.
•
On, lit steadily — The unit is
powered on.
Blinking — The unit is
•
powering up or the HCR 102
is performing a reset. The
blink pattern depends on the
selected reset mode.
For full descriptions of reset
modes, how to use the reset
button to activate them, and details
of LED indications of each mode,
see the HC 400 Series User Guide.
MENU
AUDIO
LPCM-2CH
MULTI-CH
ENTER
E
FG
arrow) buttons (see
Reset
HOLD
FOR 720p/1080p
HCR 102
H
I
HDMI IN
Input
2
e
HCT 101 EU Front (With Frame)
HDMI IN
e
HCT 101 MK Front (With Frame)
NOTE:
For other connectors on
the HCT, see
Rear and Side
Panel Features
on page 3.
Advertisement
Table of Contents
