[Pr. Pf29_Function Selection F-10 (*Fop10)]; [Pr. Pf31_Machine Diagnosis Function - Friction Judgment Speed (Fric)] - Mitsubishi Electric Melservo-Jet MR-JET-G User Manual

[Pr. PF29_Function selection F-10 (*FOP10)]

Initial value
00000000h
[Pr. PF29.1_State selection with forced stop in progress]
Initial value
0h
Select the PDS state transition for when the forced stop is in progress.
Select whether to enable/disable use of the Quick stop function when the servo amplifier detects a forced stop signal off
during operation of the servo motor.
0: Operation enabled
1: Quick stop active
[Pr. PF31_Machine diagnosis function - Friction judgment speed
(FRIC)]
Initial value
0 [r/min], [mm/s]
Set the servo motor speed to divide the friction estimation area between low-speed and high-speed in the friction estimation
process of machine diagnosis.
When the maximum operation speed is under the rated speed, it is recommended to set half the value of the maximum
operation speed.
When "0" is set, the judgment speed is half of the rated speed.
The setting value will be clamped at the maximum speed. When changing the speed to the permissible speed, set the speed
in [Pr. PA28.4 Speed range limit selection].
By setting [Pr. PF34.6 Friction estimate area judgment speed setting] to "1" (automatic setting), this servo parameter value will
be automatically calculated from the operation pattern during servo motor driving and overwrite the value.
Forward direction
Servo motor
0 r/min
speed
Reverse direction
1 SERVO PARAMETER DETAILS
82
1.7 Extension setting 3 servo parameters group ([Pr. PF_ _ ])
Setting range
Refer to the relevant detail No.
Setting range
Refer to the text
Setting range
0 to 65535
Maximum speed in operation
Setting value of [Pr. PF31]
Operation pattern
Ver.
Refer to the relevant detail No.
Ver.
B2
Ver.
A4