[Pr. Npa02_Ip Address]; [Pr. Npa04_Subnet Mask] - Mitsubishi Electric Melservo-Jet MR-JET-G User Manual

[Pr. NPA02_IP address]

Initial value
192.168.3.1 (C0A80301h)
Set the IP address.
Set each octet to a value between 0 to 255.
In the eight digits of hexadecimal, the first to forth octets are expressed with each pair of digits.
Two Two Two Two
digits digits digits digits
4th octet
3rd octet
2nd octet
1st octet
Set the IP address assigned by the network administrator.
Refer to the following for the relation to the rotary switch.
Page 148 [Pr. NPA01_IP address setting]
When SLMP command (IPAddressSet) is received at the time of IP address delivery from the controller, this network
parameter is overwritten with the received IP address.
To enable this network parameter, cycle the power or reset the software after setting.
This network parameter cannot be rewritten via the parameter automatic setting.

[Pr. NPA04_Subnet mask]

Initial value
255.255.255.0 (FFFFFF00h)
Set the subnet mask.
Set each octet to a value between 0 to 255.
In the eight digits of hexadecimal, the first to forth octets are expressed with each pair of digits.
Two Two Two Two
digits digits digits digits
4th octet
3rd octet
2nd octet
1st octet
Set the subnet mask assigned by the network administrator.
When SLMP command (IPAddressSet) is received at the time of IP address delivery from the controller, this network
parameter is overwritten with the received subnet mask.
To enable this network parameter, cycle the power or reset the software after setting.
This network parameter cannot be rewritten via the parameter automatic setting.
Setting range
Refer to the text
Setting range
Refer to the text
Size
4 bytes
Size
4 bytes
5 NETWORK PARAMETER DETAILS
5.1 Network basic parameters
Ver.
A4
Ver.
A4
149
5