Christie Mirage SST User Manual page 21

8. On the projector beside the AC inlet, move the AC breaker/switch to the on position.
The projector boots into standby mode after approximately 30 seconds.
9. Once the projector is in standby, on the projector keypad or the projector remote, press and
hold the power
The projector can also be turned on using the web user interface. After a few seconds, the
projector moves to the on state, causing the yellow light on the laser illumination source to
turn off. The laser is ready to be turned on but no illumination occurs until the green button is
pressed and the lasers have warmed up.
10. On the laser illumination source, press the green Start button (D).
The two Emission status indicators (E) turn red. When the lasers are warmed up and the
projector is ready, you can display an image (use test pattern if no source image is
connected).
On the projector, the Status > Laser Info > Laser Bank State menu displays the message
"Warming Up". When that message disappears, the lasers are ready. It typically takes the
Mirage SST User Guide
020-102993-01 Rev. 1 (06-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
button until you hear a beep.
Operating the projector
21