Setting Up 1D Color Uniformity - Christie Mirage SST User Manual

Setting up 1D color uniformity

Learn how to set up 1D color uniformity on the projector after taking measurement of each of the
color primaries at points (15, 2, 5, 8, and 16).
1. Ensure the projector is running in representative ambient light.
2. Setup a spectroradiometer, such as the CR-250, on a tripod.
If not using the CR-250 or better, Christie recommends placing the meter perpendicular to the
screen to achieve accurate measurements.
Do not use the PR-655 spectroradiometer to perform color uniformity on a multi-projector
installation.
3. Power on the projector.
4. Allow the light source to stabilize.
5. Select MENU > Configuration > Horizontal 1D Color Uniformity.
6. To disable color uniformity, select Color Uniformity Mode.
7. Select Enter.
8. Select MENU > Image Settings > Color & Gamma > Color Correction Mode.
9. Select Max Drives and to confirm your selection, select Enter.
10. Select Show Color Pattern > Auto and to confirm your selection, select Enter.
11. From the side panel home page, use the arrows to select Test Pattern.
12. Select the 17 Point test pattern and to confirm your selection, select Enter.
13. Record the x, y, and RGB luminance values for the center point.
a) Point the spectroradiometer at point 5 (middle square).
b) Click the X value.
c) Record the x value from the spectroradiometer.
d) Click the Y value.
e) Record the y value from the spectroradiometer.
f) Click on the Red luminance setting.
The display changes to the appropriate color.
g) Record the luminance value from the spectroradiometer.
h) Click on the Green luminance setting.
The display changes to the appropriate color.
i) Record the luminance value from the spectroradiometer.
j) Click on the Blue luminance setting.
Mirage SST User Guide
020-102993-01 Rev. 1 (06-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Configuring system settings
38