Turning On The Projector With Low Voltage - Christie Mirage SST User Manual

The display changes to the appropriate color.
k) Record the luminance value from the spectroradiometer.
14. Record the luminance values for the remaining four points (2—inside left, middle square; 15—
far left, middle square; 8—inside right, middle square; and 16—far right, middle square)
a) Point the spectroradiometer at a point.
b) Click on the Red luminance setting.
The display changes to the appropriate color.
c) Record the luminance value from the spectroradiometer.
d) Click on the Green luminance setting.
The display changes to the appropriate color.
e) Record the luminance value from the spectroradiometer.
f) Click on the Blue luminance setting.
The display changes to the appropriate color.
g) Record the luminance value from the spectroradiometer.
h) For the remaining three points, repeat steps a to g.
15. Select MENU > Configuration > Horizontal 1D Color Uniformity.
16. To enable color uniformity, select Color Uniformity Mode.
17. Select Enter.
18. To verify 1D color uniformity is working, enable a flat white test pattern.

Turning on the projector with low voltage

Enable the projector to turn on even if the AC mains voltage is below specification.
1. From the display panel, select MENU > Admin > Service.
2. Enter the service password.
3. Select Ignore Low AC Input Voltage Error.
4. To ignore the Low AC Input Voltage error when turning on the projector, select Enter.
Mirage SST User Guide
020-102993-01 Rev. 1 (06-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Configuring system settings
39