Error Message - Brother HL-L8250CDN Service Manual

3.2

Error Message

The error messages displayed on the LCD of the machine and their description are shown in
the table below.
■
Model without touch panel
1st line
Access
Denied
Access Error Press Cancel. Put
Belt End
Soon
Calibrate
Error Message
2nd line
Function Locked.
Function Locked.
Job Deleted. Press
Go.
Function Locked.
Press Go.
the device back in
and try again
-
Calibration failed.
Insufficient Toner
for Calibration.
Calibration failed.
Press Go, and try
again.
Calibration failed.
Turn the power off
and then back on
again.
State
In the case of PC-print,
authentication of print restricted
ID failed.
The USB flash memory is taken
out while data is being
processed.
Number of pages printed with the
belt unit will reach the upper limit
soon.
Dot counter or develop roller
counter of color toner has
reached the upper limit during
color density adjustment
performed from the control panel.
Density patch measurement
ended unsuccessfully during
color density adjustment
performed from the control panel.
Error occurred with the value
measured during density sensor
sensitivity calibration.
Error occurred with the value
measured during color density
adjustment performed from the
control panel.
2-20
Error Refer
Codes to:
--- 4.10.3
--- 4.10.3
--- 4.10.3
--- 4.11.2
4300 2-48
9802 2-70
9803 2-71
9804 2-71
9801 2-70
Confidential