Brother HL-L8250CDN Service Manual page 322

1.3.18 Frame pattern print (One-sided) (Function code 69)
<Function>
This function is used to print one page of the frame pattern of the external circumference in
one-sided printing and check if there is any deviation or omission of print.
<Operating procedure>
Model without touch panel
(1) Load the paper whose size matches the
default paper setting (A4 or Letter) into
the paper tray.
(2) Press the
"MAINTENANCE 69" on the LCD in the
initial state of the maintenance mode.
Then, press the OK key. "PRINTING" is
displayed on the LCD, and the frame
pattern (see the figure below) is printed on
a single side of the paper.
(3) When print is completed, "WAKU SX" is
displayed on the LCD.
(4) Press the Cancel key and finish this
operation to return the machine to the
initial state of the maintenance mode.
Note:
If printing fails, the following error indications are displayed on the LCD, and printing is
cancelled. To print again, refer to the measures in the table below and remove the cause of
the error. Then, press the Go key for the model without a touch panel and the Mono key for
the model with a touch panel. "PRINTING" is displayed on the LCD, and the frame pattern
is printed on a single sheet.
Error message
Replace Toner
Cover is Open
No Paper
Jam Tray1
Jam Rear
■
Frame pattern
or key to display
Replace the empty toner cartridge and press the Go key for the
model without a touch panel and the Mono key for the model with
a touch panel to clear the error.
Close the front cover.
Load paper into the paper tray, close the paper tray, and press the
Go key for the model without a touch panel and the Mono key for
the model with a touch panel to clear the error.
Remove the jammed paper, close the paper tray and all the
covers, and press the Go key for the model without a touch panel
and the Mono key for the model with a touch panel to clear the
error.
Fig. 5-13
5-39
Model with touch panel
(1) Load the paper whose size matches the
default paper setting (A4 or Letter) into
the paper tray.
(2) Press the 6 and 9 keys in this order in
the initial state of the maintenance
mode. "PRINTING" is displayed on the
LCD, and the frame pattern (see the figure
below) is printed on a single side of the
paper.
(3) When print is completed, "WAKU SX" is
displayed on the LCD.
(4) Press the X key and finish this
operation to return the machine to the
initial state of the maintenance mode.
Measure
Confidential