Brother HL-L8250CDN Service Manual page 289

1.3.3 Worker switch (WSW) setting and printout (Function code 10, 11)
[1] Worker switch (WSW) setting (Function code 10)
<Function>
The worker switches shown in the table below can be used to set the function to satisfy
various requirements. The switch setting can be changed using the keys on the control panel.
The worker switches are factory set to conform with the laws and regulations of the country the
machine is shipped to. Do not change these settings unless necessary.
WSW No.
WSW17 Selector 5
WSW47 Selector 8
WSW56 Selector 1
WSW56 Selector 6
WSW56 Selector 7
WSW56 Selector 8
WSW59 Selector 1
WSW63 Selector 1-2
WSW63 Selector 3
WSW63 Selector 4-7
WSW63 Selector 8
WSW64 Selector 1-6
WSW64 Selector 7-8
WSW65 Selector 1-2
WSW65 Selector 3
WSW65 Selector 4
WSW65 Selector 6
WSW78 Selector 1
<Operating procedure>
Model without touch panel
(1) Press the
"MAINTENANCE 10" on the LCD in the
initial state of the maintenance mode.
(2) Press the OK key. The machine
displays "WSW00" on the LCD and
becomes ready to accept a worker
switch number.
(3) Press the
worker switch number whose setting
you want to change on the LCD.
Switching of the time display method (between the American
method (MM/DD/YY**) and European method (DD/MM/YY**))
Switching between high-speed USB and full-speed USB
Enabling and disabling setting of PS Emulation
Switching of the display for the coverage of toner cartridge
Enabling and disabling switching of PCL Emulation
Switching of the CPU sleep mode
Enabling and disabling of transmission of USB serial number (SN)
Switch of the print speed
Switching of the time display method (between the Japanese
method (YY/MM/DD**) and other methods)
Demo print type
Font support for Israel
Language setting
Default paper size
Default media type
Support for Bond paper
Support for Hagaki
Support for Label
Recording stop function when the drum reaches the end of life
or key to display
or key to display the
5-6
Function
Model with touch panel
(1) Press the 1 and 0 keys in this order in
the initial state of the maintenance
mode. "WSW00" is displayed on the
LCD.
(2) Enter the number of worker switch to
change.
The following is displayed on the LCD.
Selector 1 Selector 8
Confidential