Brother HL-L8250CDN Service Manual page 295

1.3.7 "One Push Demo" setting (Function code 28)
<Function>
The One Push Demo function is to implement demo printing by pressing a specified key,
which is mainly used for sales promotion at the shop. This function is disabled once printing is
performed from the computer. Change the setting to enable the function.
OnePushDemo = ON (Enabled)/OFF (Disabled)
The setting currently selected is marked "*".
<Operating procedure>
Model without touch panel
(1) Press the
"MAINTENANCE 28" on the LCD in the
initial state of the maintenance mode.
Then, press the OK key. "One Push
Demo=ON" is displayed on the LCD.
(2) To enable the function, display
"OnePushDemo=ON" using
the or
function, display
"OnePushDemo=OFF".
(3) Press the OK key. The displayed
setting is confirmed and the machine
returns to the initial state of the
maintenance mode.
Note:
- To terminate this operation, press the Cancel key for the model without a touch panel and
X key for the model with a touch panel. The machine returns to the initial state of the
maintenance mode.
- Once the One Push Demo function is enabled, printing from a computer does not disable
this function unless the power is turned OFF. After the One Push Demo function is
enabled, if the power is turned OFF and ON again, and then printing is made from a
computer, the function is disabled.
or key to display
key. To disable the
5-12
Model with touch panel
(1) Press the 2 and 8 keys in this order in
the initial state of the maintenance
mode. "One Push Demo=ON" is
displayed on the LCD.
(2) To enable the function, display
"OnePushDemo=ON" using
the or key. To disable the
function, display
"OnePushDemo=OFF".
(3) Press the SET key. The displayed
setting is confirmed and the machine
returns to the initial state of the
maintenance mode.
Confidential