Brother HL-L8250CDN Service Manual page 51

Error Message
1st line
Load #S paper and
Size
press Go.
Mismatch
Load #S paper in
#T and press Go.
Open the Back
Small paper
Cover and then
press Go.
Change Emulation
Table Print
One or more Toner
Toner Error
Cartridges are not
detected.
Pull out and
reinsert all 4 Toner
Cartridges.
-
Toner Low:
BK
-
Toner Low:
C
-
Toner Low:
M
Toner Low: Y -
Take out Tray 2 and
Tray 2 Error
push it back in
firmly.
2nd line
The size of paper loaded in the
paper tray 1 and the one
specified from the driver are not
same when paper is fed from the
paper tray 1.
The size of paper loaded in the
MP tray and the one specified
from the driver are not same
when paper is fed from the MP
tray.
The size of paper loaded in the
T2 paper tray unit and the one
specified from the driver are not
same when paper is fed from the
T2 paper tray unit.
The paper size which is not
supported by the output tray is
set for printing from the printer
driver.
While Emulation is fixed to PS,
Table Print was performed.
The develop release sensor
detected the developer roller
disengagement or engagement
failure.
Dot counter of the toner cartridge
(Black) or develop roller counter
reaches the upper limit soon.
Dot counter of the toner cartridge
(Cyan) or develop roller counter
reaches the upper limit soon.
Dot counter of the toner cartridge
(Magenta) or develop roller
counter reaches the upper limit
soon.
Dot counter of the toner cartridge
(Yellow) or develop roller counter
reaches the upper limit soon.
After the T2 paper tray unit is
opened and closed or the power
is turned ON, the T2 plate origin
sensor detects that lift-up of the
plate of the T2 paper tray unit is
not completed within the
specified period of time.
2-28
Error
State
Codes
9002
9001
9003
8D02
6E00
4B01
4B04
4B03
4B02
6C02
Refer
to:
2-66
2-66
2-66
2-66
--- 4.11.1
2-59
2-49
2-49
2-49
2-49
2-58
Confidential