Replacing Failed Raid Controller - Avid Technology FastServe Playout Setup Manual

8. Release the PHY interface and then slide it out of the chassis.

Replacing Failed RAID Controller

In the event that you have one or more RAID controller failures, you can replace them.
n
The system should be taken offline and powered down before replacing boards.
Before you begin, you must obtain replacement RAID controller for your FastServe | Playout server.
To replace failed RAID controller:
1. Observe the safety precautions described in
and "Safety and Regulatory Information".
2. Power down the server and unplug all peripheral devices and the AC power cables.
3. Remove the server cover.
4. Disconnect any cables that might be in danger when you are replacing the RAID controller.
5. Identify the RAID controller in your chassis:
"Electrostatic Discharge Precautions" on page 21
54