Check Bios Configuration; Loading Centos 7 Image On Fastserve | Playout - Avid Technology FastServe Playout Setup Manual

Check BIOS Configuration

In the event that you need to reimage your FastServe | Playout server, you should check your BIOS
settings before re-installing the Centos 7 software.
To check if BIOS is configured correctly:
1. Turn on or restart your FastServe | Playout server.
2. Press the Esc button during the server start.
3. Press Esc after the initial screen appears to enter boot settings.
4. Set the following parameters:
a. Advanced > Processor Configuration > Hyper trade = Disable.
b. Advanced > H2O IPMI > BMC configuration >
- IPV4 Source <Static>
- IPv4 IP (Ex: 10.10.31.2xx)
- IPv4 Subnet Mask (Ex: 255.255.224.0)
- IPv4 Gateway Address (Ex: 10.10.0.254)
c. Advanced > IIO Configuration > IIO0 Configuration > IOU0 (IIO PCIe Port 2) = x8x8
d. Advanced > System Event Log > IO0 Error Enable <No>
e. Advanced > System Event Log > PCI-Ex Error Enable <No>
5. Press F10 to save the configuration and exit.

Loading Centos 7 image on FastServe | Playout

This topic contains information on how to load the Centos 7 restore image on your AFastServe |
Playout system.
47