Meaning Of The Leds On The Terminal Module Tm54F - Siemens SINAMICS S120 Combi Equipment Manual

9.1.3.15

Meaning of the LEDs on the Terminal Module TM54F

Table 9- 14 Terminal Module TM54F - description of LEDs
LED Color
READY -
Green
Orange
Red
Green/red
Green / Orange
or
Red / Orange
L1+, L2+, –
Red
L3+ –
Red
Fail-safe inputs / double inputs
F_DI z LED LED
(input x, x x+1
(x+1)+, – Red
(x+1)-) –
– Red
– –
LED LED
x
Green Green
Green Green
Inputs x+1 (DI 1+, 3+, .. 19+) can be set individually via parameter p10040 (TM54F).
1)
p10040 (TM54F) = 0: Input x+1 is an NC contact.
p10040 (TM54F) = 1: Input x+1 is NO contact.
Factory setting: p10040 (TM54F) = 0 for all inputs x+1.
SINAMICS S120 Combi
Manual, Edition 05.2010, 6SL3097-4AV00-0BP0
Status
Off Electronics power supply is missing or outside permissible
tolerance range.
Continuous The component is ready for operation and cyclic DRIVE-
light CLiQ communication is taking place.
Continuous DRIVE-CLiQ communication is being established.
light
Continuous At least one fault is present in this component.
light Note:
The LED is activated irrespective of whether the
corresponding messages have been reconfigured.
0.5 Hz Firmware is being downloaded.
flashing light
2 Hz Firmware download is complete. Wait for POWER ON
flashing light
Flashing Component recognition via LED is activated (p0154).
light
Note:
Both options depend on the LED status when component
recognition is activated via p0154 = 1.
ON The controllable sensor power supply is functioning fault-
free.
Continuous There is a fault in the controllable sensor power supply.
light
ON Sensor power supply is functioning fault-free.
Continuous There is a fault in the sensor power supply.
light
NC contact / NC contact
Continuous Different signal states at input x and x+1
– light No signal at input x and no signal at input x+1
–
Continuous NC contact / NO contact
light Same signal states at input x and x+1
– No signal at input x and a signal at input x+1
x+1
Continuous NC contact / NC contact
light A signal at input x and a signal at input x+1
Continuous NC contact / NO contact
light A signal at input x and no signal at input x+1
Additional system components
9.1 Terminal Module TM54F
Description, cause
: (z = 0..9, x = 0, 2, ..18)
1)
: (z = 0..9, x = 0, 2, ..18)
1)
: (z = 0..9, x = 0, 2, ..18)
1)
: (z = 0..9, x = 0, 2, ..18)
1)
Remedy
–
–
–
Remedy and
acknowledge
fault
–
Carry out a
POWER ON
–
–
–
–
–
189