Power Cables For Motor; Approved Power Cables - Siemens SINAMICS S120 Combi Equipment Manual

Cabinet design and EMC
12.7 Cable shielding and routing
12.7.4

Power cables for motor

12.7.4.1

Approved power cables

Note
Only MOTION-CONNECT 500 and MOTION-CONNECT 800 power cables are permissible
for the S120 Combi.
Table 12- 9 Approved power cables for motors connected to the S120 Combi - pre-assembled
Motor
1PH8 with terminal box
1PH8 with terminal box
1PH8 with terminal box
1FT7/1FK7 with fast release
1PH8 with connector with fast release 5DF11
1PH8 with connector with fast release 5CF12
1PH8 with connector
without fast release
⃞... 5 = MC500, 8 = MC800
Note
If the connecting cables for a 24 V motor holding brake are included in the power cable, then
only the specified cables must be used. These cables must have a separate shield for the
24 V and must be suitable for safe electrical separation.
The cable shield of the motor holding brake cores must be connected at both ends.
Note
In order that the specified EMC limit values (EN 61800-3) are maintained, only shielded type
MC500 and MC800 power cables must be used. The permissible cable length is 25 m for
rated output currents I
The total cable length for the complete drive line-up is 175 m.
258
Order number Description
6FX⃞002-
5CE02 Power cable 1PH808 4 x 2.5
5CE04 Power cable 1PH810 4 x 4
5CE06 Power cable 1PH813 4 x 6
5CF10 Power cable 4 x 1.5 GR.1 SC
5DF10 Power cable 4 x 1.5 + 2 x 1.5 GR.1 SC
Power cable 4 x 2.5 GR.1.5 SC
Power cable 4 x 4 GR.1.5 SC
5CF13 Power cable 4 x 10 GR.3
from 5 A to 30 A.
n
SINAMICS S120 Combi
Manual, Edition 05.2010, 6SL3097-4AV00-0BP0
D
max
6FX5 6FX8
10.0 12.1
11.4 13.2
13.6 16.0
8.4 10.4
10.8 12.9
10.0 12.1
11.4 13.2
20 19.4