S1 Dip Switch - Siemens SINAMICS S120 Combi Equipment Manual

DC link components
7.2 Control Supply Module CSM
7.2.3.6

S1 DIP switch

Table 7- 11 DIP switch S1
Terminal
1
2
The changeover is only made in the no-voltage state.
Figure 7-10 DIP switch on the upper side of the component
When delivered, "single operation" is set. Both switches are set to the left.
Note
The DIP switch must be set to "single operation" when operating the Control Supply Module
on the S120 Combi.
164
Designation
Changeover switch, single
operation / parallel operation
Dummy contact
(not used)
Technical specifications
Left: Single operation
Right: Parallel operation
Changing over the output characteristic
Manual, Edition 05.2010, 6SL3097-4AV00-0BP0
SINAMICS S120 Combi