Table of Contents
Advertisement
Start-up
PLATPH [Parameter]
* Parameters
-a<n>
-q<n>
10
-i<n>
-r
-c <path name> Specifies the data file containing the calibrated value obtained from
the PLCALIB.EXE application (touch panel data calibration).
At startup, the following message will appear on the screen.
After startup, these commands reside in memory.
• If an error is generated because, for example, there is no file created by the
PLCALIB.EXE application, the following message appears on the screen, and the
system will start up in a mode that does not calibrate data.
• Unless properly calibrated, the display and touch panel input positions may not be the same.
6-4
[↵]
or PLATPH -r
Specifies the I/O base address of the touch panel's SIO port.
n=
Specifies the interrupt level (IRQ) of the touch panel's SIO port.
11
(COM4)
Sets the software interrupt vector number when calling up functions.
Hexadecimal, Default: n=59
Cancels the resident command.
When defaulted to, the PLATPH.CAL of the current directory is specified.
∗ Example platph -a2e8 -q10 -cc:\platph.cal
Normally, only "platph" is needed.
Analog Touch Panel Handler PLATPH.EXE Version X.XX
Copyright (c) 199X Digital Electronics Corporation
Stay resident.
WARNING!! Can't open CAL file.
Stay resident.
[↵]
Hexadecimal, Default: 2e8 (COM4)
3f8 (COM1)
n
2f8 (COM2)
3e8 (COM3)
2e8 (COM4)
Default: 10 (COM4)
n= 4
(COM1)
3
(COM2)
(COM3)
PL-5700 Series User's Manual
Bundled Software
Advertisement
Table of Contents
