PROFACE PL-5700 Series Manual page 41

Optional Units and Expansion Boards
Development and Maintenance Type (PL-FD001)
Attaching the mounting hardware
To attach to the rear panel
To attach to the side panel
When attaching to the PL Chassis
Bottom panel of the PL
PL-5700 Series User's Manual
3. To install the PL-FD000, slide the unit
down toward the front panel of the PL.
Tighten the six screws on the side and
bottom panels.
To install the PL-FD001 on the REAR panel
of the PL, use the four screws which came
with the FDD unit to attach the mounting
brackets on the top and bottom panels of
the FDD unit.
To install the PL-FD001 on the PL's other
panel, use the four screws which came with
the FDD unit to attach the mounting brack-
ets on the side panels of the FDD unit
1. Loosen the six screws on the side and
bottom panels of the PL to remove the
dummy unit or optional PL-MC000
unit.
The figure shows the 3-slot type of PL-5700T1
• Be careful not to pinch the cable be-
tween the PL body and FDD unit.
This may damage the cable.
• The rear maintenance hatch may not
have screw holes depending on the
date of purchase of the PL. If so,
contact a Digital Service Center.
3-11