Table of Contents
Advertisement
Optional Units and Expansion Boards
3-2 Installing Options and Expansion Boards
To avoid electric hazards, be sure to turn the PL's power OFF before installing
any optional units or expansion boards.
Use a screw driver to loosen or tighten the screws. Be careful not to over-tighten any
screws, since it may damage the equipment.
The procedures explained in this section apply to all PL models, even though only the
PL-5700T1 is shown.
1
Installing DIM Modules
Be careful when inserting the DIM module into the socket since the clips at both ends
of the module are easily bent.
Determine your unit's DIM module combination from the table below.
Total capacity (MB)
B ANK 0
B ANK 1
Installing one 8-MB module and one 16 MB module provides 20 MB of memory, not 24
MB.
If you use only one module, be sure to install it in BANK 0. If you use two modules, install
the first in BANK 0, and the second in BANK 1.
PL-5700 Series User's Manual
WARNING
( PL-EM000/EM001/EM002 )
4
8
4
4
8
-
4
-
Rear maintenance cover
DIMM sockets
12
16
4
8
16
8
8
-
1. Unscrew and remove the rear main-
tenance cover.
BANK 1 (Upper socket)
BANK 0 (Lower socket)
20
32
4
8
16
16
16
16
3-3
Advertisement
Table of Contents
