PROFACE PL-5700 Series Manual page 42

Side panel of the PL
PL-FD001
3-12
Optional Units and Expansion Boards
Rear maintenance
cover
Remove
the dummy unit
FDD connector
2. Insert the PL-FD001 cable into the FDD connec-
tor.
3. Use the four plastic screws which came with the
FDD connector to attach the PL-FD001 to the
PL's rear maintenance cover.
4. Take the PL-FD001 cable out as shown in the
figure, and slide the dummy unit or optional PL-
MC000 toward the front panel to set it in place.
Then, tighten the six attachment screws on the
PL's side and bottom panels.
• To prevent short circuits with the expansion
board inserted in the slot, use only the plastic
screws which came with the PL-FD001 to
mount the FDD unit on the rear maintenance
cover.
• Be careful not to pinch the cable between the
PL body and FDD unit. This may damage the
cable.
• If the cable is too long or contacts the 100
VAC input terminals and AC power cord, se-
cure the cable with the PL-FD001's cable
clamps.
• When installing the PL-MC000,
keep the cable away from the memory
card's interface. Otherwise, the
memory card cannot be installed.
PL-5700 Series User's Manual