Table of Contents
Advertisement
Chapter
4
Installation and Wiring
This chapter describes how to install and wire the PL.
4-1 Installing the PL
1
Installation Procedures
Install the PL following the instructions given below.
Screw in the front maintenance hatch's attachment screws
To improve the PL's moisture and dust resistance, secure the PL's front maintenance
cover in place before installing the PL into a control or operation panel. (This pro-
vides protection equivalent to IP65F. If merely clipped on, the protection level is
equivalent to IP63F)
Panel Computer PL-5700 Series User's Manual
Insert these two screws
Front maintenance cover
4-1
Installing the PL
4-2
Wiring the PL
To access the maintenance cover's attach-
ment screw holes, first remove either the
dummy or optional unit, located in the rear
of the PL (see step 1 in "3-2-4 Installing
the FDD Unit"). This will expose the front
maintenance cover's attachment screw
holes. (See figure on left) Then, use a
screwdriver to insert the two cover attach-
ment screws into their respective cover
holes (use only M3x6 screws). When the
maintenance cover is secured, replace the
previously removed unit.
4-1
Advertisement
Table of Contents
