Table of Contents
Advertisement
System Set-up
COM 1 Port
This setting designates the value used for the PL's COM 1 port address. The
selections include [Disabled], [3F8/IRQ4], [2F8/IRQ3], [2E8/IRQ3] and [Auto].
The factory setting is [3F8/IRQ4] and is recommended.
COM 2 Port
This setting designates the value used for the PL's COM 1 port address. The
selections include [Disabled], [2F8/IRQ3], [3E8/IRQ4], [2E8/IRQ3] and [Auto].
The factory setting is [2F8/IRQ3] and is recommended.
LPT Port
This setting designates the value used for the PL's LPT port address. The selec-
tions include [Disabled], [3BC/IRQ7], [378/IRQ7], or [278/IRQ5]. When using
any setting other than [Disabled], the LPT mode setting must be changed to [Outout
Only] or [Bi-Directional]. The factory setting is [3BC/IRQ7] and is recommended.
LPT Mode
This setting designates the mode of the PL's PLT port address. The selections
include [Output Only] (unidirectional), and [Bi-Directional] (both directions).
The factory setting is [Output Only] and is recommended. When the LPT Port is
set to [Disabled], this setting is also disabled.
Diskette controller
The selections include [Disabled] or [Enabled]. The factory setting is [Enabled]
and is recommended.
IDE adapter
The selections include [Disabled] or [Enabled]. The factory setting is [Enabled]
and is recommended.
PL-5700 Series User's Manual
5-7
Advertisement
Table of Contents
