38. DISC BRUSH DISASSEMBLY
1. Lift the base by turning the right lever (1) to move the base counterclockwise.
WARNING: Before performing any maintenance, remove the keys from the
panel and disconnect the battery connector of the machine.
WARNING: During this operation, check there are no people or objects near the
brush.
2. Rotate the brush counter-clockwise until it comes out of the brush-holder plate seat, as shown in
the figure.
ATTENTION: you are advised to always wear protective gloves, to avoid the risk
of serious injury to your hands.
You are advised to invert the right and left-hand brushes every day. If the brushes are not new however,
and have deformed bristles, it is better to reassemble them in the same position (the right-hand one on
the right, and the left-hand one on the left), to prevent the different inclination of the bristles producing
an overload on the brush motor as well as excessive vibrations.
DAILY MAINTENANCE
25