At The End Of The Work - COMAC INNOVA 65 B M 2011 Use And Maintenance Manual

At the end of the work, and before carrying out any type of maintenance, perform the following
operations:
1. Close the tap (1)
2. Raise the brush head by turning the right-hand lever (2) anticlockwise. Then raise the squeegee
by turning the left-hand lever (3) clockwise. After about 15-25 seconds, switch off the suction
motor by making a 1/4 turn of the key, anticlockwise.
3. Make a 1/4 turn of the key clockwise, and take the machine to the designated water drainage area
4. Turn the machine off by turning the key one quarter turn anticlockwise and remove it from the panel.
5. Engage the parking brake
WARNING: Before performing any maintenance, remove the keys from the
panel and disconnect the battery connector of the machine.
6. Disconnect the tube (3) from its seat, unscrew the drainage cap and empty the recovery tank.
WARNING: this operation must be carried out by using gloves in order to
protect against contact with dangerous solutions.
7. Slide the suction tube (4) from the squeegee sleeve
8. Remove the squeegee (5) from the support arm by unscrewing the handwheel (6).
9. Clean well both the squeegee and the rubbers with a jet of water.
10. After cleaning the squeegee and rubbers, replace the squeegee on the initial support, firstly inserting
the left pin of the squeegee in the left slot of the arm, then the right pin in the right slot, being careful
to keep the spring and washer on the plate of the arm. This can be simplified by first loosening the
handwheel on the pin. Then retighten the handwheel to block the squeegee in place.
11. Finally insert the squeegee tube in the special sleeve.
12. Lift the recovery tank and connect the battery connector
13. sit on the driver's seat
14. Insert the key into the ignition switch and turn it a quarter turn clockwise (to position ON)
15. Disengage the parking brake
16. Park the machine in a closed place, in an area where it cannot cause damage to people or other
property, but also be protected from an accidental fall of objects.
17. Engage the parking brake
18. Turn the ignition key a quarter turn anticlockwise (OFF position) and remove the key
19. Lift the recovery tank and disconnect the battery connector
ATTENTION: do not leave the machine unattended without first removing the
start-up switch key and applying the parking brake. In addition, do not park the
machine in open places or on sloping floors .

AT THE END OF THE WORK

22