Inserting Water System Filter; Assembling The Brush (Scrubbing Version); Assembling The Brush (Sweeping Version); Assembling The Abrasive Pad (Orbital Version) - COMAC Vega 2019 Use And Maintenance Manual

CAUTION: keep the recovery tank open for the duration of the battery recharging cycle to allow gas fumes to escape.
• Once the recharge cycle has been completed, rotate the recovery tank to the maintenance position
and disconnect the battery charger's cable from the battery connector.
• Connect the electrical system connector to the battery connector.
• Grip the handle (5) on the left-hand side of the recovery tank (Fig.7) and turn the recovery tank until it reaches the work position.

INSERTING WATER SYSTEM FILTER

Before using the machine for the first time the water system filter needs to be reset, for shipping reasons the filter cartridge and the cap have been
removed. To insert the filter cartridge in the water system filter body proceed as follows:
1. Take the machine to the maintenance area.
2. Make sure the machine has been secured (see the section titled
CAUTION: It is recommended that you wear the PPE (Personal Protective Equipment) suited to the work to be carried out.
3. Tighten the outlet flow of the tap, turn the lever (10) on the back of the machine anti-clockwise (Fig.12).
4. Move to the right-hand side of the machine, insert the filter cartridge (11) in the housing on the cap (12) (Fig.13).
N.B.: The O-ring gasket in the filter cartridge should be inserted into its seat in the cap.
5. Screw the cap (12) onto the body of the detergent solution filter (Fig.14).

ASSEMBLING THE BRUSH (SCRUBBING VERSION)

To assemble the brushes to bush head body, which for reasons of packaging are supplied dismantled from the machine, proceed as follows:
1. Perform the procedure for securing the machine ( see the section titled
CAUTION: It is recommended that you wear the PPE (Personal Protective Equipment) suited to the work to be carried out.
2. With the brush head in the raised position, remove the brush head splash guards (13) (Fig.15).
3. Insert the brush into the flange on the brush head body, press the brush-holder plate retainer (14) and simultaneously rotate the brush in the
direction shown in the image (Fig.16).
ATTENTION: Fig.16 shows the rotation direction of the left-hand brush, rotate in the opposite direction for the right-hand brush.
4. Repeat the operations completed for the right-hand front brush as well.

ASSEMBLING THE BRUSH (SWEEPING VERSION)

To assemble the brushes to bush head body, which for reasons of packaging are supplied dismantled from the machine, proceed as follows:
1. Perform the procedure for securing the machine ( see the section titled
CAUTION: It is recommended that you wear the PPE (Personal Protective Equipment) suited to the work to be carried out.
2. With the brush head raised from the floor, turn the knobs (15) that hold the left lateral carter (16) in place anti-clockwise (Fig.17). Remove the
left-hand side carter.
3. Insert the brush into the tunnel, taking care to make sure that the gearmotor's drive shaft enters the slit in the brush itself.
4. Repeat the previously described operations for the right-hand side as well.
N.B.: In order to be installed correctly, the brushes must form an X when viewed from above in the forward direction of movement (Fig.18).

ASSEMBLING THE ABRASIVE PAD (ORBITAL VERSION)

For packaging reasons, the abrasive pad comes disassembled from the machine. To assemble it on the brush head body, proceed as follows:
1. Perform the procedure for securing the machine ( see the section titled
CAUTION: It is recommended that you wear the PPE (Personal Protective Equipment) suited to the work to be carried out.
2. With the brush head raised above the floor, insert the abrasive pad under the brush head body.
"SECURING THE MACHINE").
"SECURING THE MACHINE").
"SECURING THE MACHINE").
"SECURING THE MACHINE").
16