Overflow Device - COMAC INNOVA 65 B M 2011 Use And Maintenance Manual

11. Lower the base by turning the right lever (4) clockwise, then lower the squeegee turning the left
lever (5) counterclockwise.
12. Pressing the accelerator pedal (6 - right pedal), the machine starts moving, both the squeegee and
the base lower and the brushes start to turn (if the i-drive switch is on the third working program)
13. To perform a reversing manoeuvre, press both pedals (6 and 7), the squeegee will rise
automatically and the machine starts to move backwards
During the first meters, check there is sufficient solution and that the squeegee dries perfectly. The
machine will start working in good working order up to run out of detergent solution or until the battery is
discharged.

33. OVERFLOW DEVICE

The machine is not equipped with an overfill device, because the capacity of the recovery tank is greater
than the capacity of the solution tank. In extraordinary cases, there is a mechanical device (float) on the lid
that, when the recovery tank is full, shuts off the air to the suction motor intake TO protect it; the sound of
the vacuum motor will then be deeper. If this happens, raise the squeegee by turning the left-hand lever
clockwise. After about 15-25 seconds, switch off the suction motor by making a 1/4 turn of the key,
anticlockwise. Make a 1/4 turn of the key clockwise, and take the machine to the designated water
drainage area. Then proceed with emptying the recovery tank through a special drainage pipe (10). It is
good practice when restoring the level of the solution tank, to empty the recovery tank through the special
drainage pipe (10).
WARNING: during machine switch-on, do not keep the accelerator pedal pressed down
WORK
21