Battery Connection And Battery Connectors; Battery Charger Connection (Versions Without Bc) - COMAC INNOVA 65 B M 2011 Use And Maintenance Manual

To insert the batteries you must:
1. Lock the machine engaging the brake lever
2. Make sure that the key switch is in the "OFF" position
3. Make sure the recovery tank is empty, otherwise empty it completely
4. Grip the handle under the seat to open the recovery tank
5. Lift the recovery tank until it hooks to the end of the safety clamp
6. house the batteries in the compartment, positioning the poles "+" and "-" opposite each other
WARNING: you are advised to use airtight batteries only, to avoid the leakage
of acids!
ATTENTION: you are advised to always wear protective gloves, to avoid the
risk of serious injury to your hands.
ATTENTION: You are advised to only lift and move the batteries with lifting
and transportation means suitable for the specific weight and size

13. BATTERY CONNECTION AND BATTERY CONNECTORS

1. connect the batteries in series - using the jumper cables supplied (3) - to the poles "+" and "-"
2. Connect the battery connector cable (1) to the terminal poles "+" and "-" to obtain a voltage of 24V on
the clamps
3. Connect the battery connector (1) to the machine connector (2).
ATTENTION: you are advised to have the electric connections made by a
qualified, COMAC-trained technician
ATTENTION: you are advised to always wear protective gloves, to avoid the
risk of serious injury to your hands.

14. BATTERY CHARGER CONNECTION (VERSIONS WITHOUT BC)

In order not to cause permanent damage to the batteries it is essential to avoid their complete discharge:
arrange the recharge within a few minutes of the switching on of the flashing "discharged batteries" signal.
ATTENTION: never leave the batteries completely discharged, even if the
machine is not being used. Check the battery charger is suitable for the
batteries installed, in terms of both capacity and type.
MACHINE PREPARATION
13
3