Filling The Solution Tank; Detergent Solution - COMAC INNOVA 65 B M 2011 Use And Maintenance Manual

21. FILLING THE SOLUTION TANK

The solution tank can be filled in three different ways:
1. Unscrew the filler cap (1) and fill using a hose.
2. Using the rubber cap (2), this supports the water hose on its own, be sure to unscrew the cap to allow
the proper vent of air.
3. Using on request (optional) a tank clean water refilling system via a quick coupling (3), FFF with float
to control the overflow.

22. DETERGENT SOLUTION

Remove the filler cap and check the solution filter (1) is correctly assembled.
Check that the filter cap, under the solution tank in the front right of the machine, is properly closed.
Fill it with clean water at a temperature not exceeding 50°C. The amount inside the tank can be seen by
means of the level pipe on the front left of the seat. The solution tank has a maximum capacity of about
110 litres. Add the liquid detergent to the tank in the concentration and manner indicated on the detergent
manufacturer's label. The formation of excess foam could damage the suction motor, so use only the
minimum amount of detergent that is necessary.
WARNING: Always use detergents whose manufacturer's label indicates their
suitability for scrubbing machines. Do not use acid or alkaline products or
solvents without this indication.
ATTENTION: Protective gloves should always be worn before handling
detergents or acidic or alkaline solutions to avoid serious injury to hands.
ATTENTION: always use low foam detergent. To avoid the production of foam,
before starting to clean, put a minimum quantity of antifoam liquid into the
recovery tank. Do not use pure acids.
MACHINE PREPARATION
17
1
2
1
3