Cisco Remote PHY Shelf 7200 Installing page 31

Installing the Cisco Remote PHY Shelf 7200
5. Install the RF cables into the port holes of the RF PIC.
The recommended cables and connectors to be used with the PIC cards are listed in the following table:
Connector/Cable
75 Ohm compression MCX
connectors
Conductor mini quad cable
75 Ohm compression F connector
for mini quad cable
Installing the Connectors into the PIC Connector Latches
To install the connector into the PIC connector latch, complete the following steps:
1. Hold the cable 0.5-1" back of the rear of the compression connector.
Installing the Connectors into the PIC Connector Latches
Description
• AMPHENOL 919-400P-71S
• MOLEX 73366-6530
• It is recommended to use a 3 conductor cable (one red conductor and
two blue).
• AMPHENOL Times Fiber PN 075I99V12ZS41500ABR1
• AMPHENOL ASFPSLCQ
• MOLEX 73356-3260
Installing the Cisco Remote PHY Shelf 7200
31