Cisco Remote PHY Shelf 7200 Installing page 30

Hide thumbs Also See for Remote PHY Shelf 7200:
Table of Contents

Advertisement

Installing the Cisco Remote PHY Shelf 7200 PIC
Step 6
Connect the positive lead cable and secure it in place with the 1/4-20 terminal bolts using a torque wrench and 7/16" hex
socket with a torque of 45-50 in-lb (5.08-5.65 Nm).
Step 7
Repeat
Step 5, on page 29
Step 8
Reinstall the terminal block covers by clipping them on the top edge of the terminal block housing and then rotating them
down until they snap into place.
Installing the Cisco Remote PHY Shelf 7200 PIC
Note
The Cisco Remote PHY Shelf 7200 PIC should be handled gently and carefully, to avoid damage to the RF
connectors.
Complete the following steps to install the Cisco Remote PHY Shelf 7200:
1. Align the Cisco Remote PHY Shelf 7200-PIC PCB to the chassis PIC guides.
2. Insert the Cisco Remote PHY Shelf 7200-PIC PCB into the chassis guides and fully seat the faceplate
against the chassis.
3. Secure PIC by tightening its faceplate captive screws.
4. Tighten captive screws to 8 Lb-In torque.
Installing the Cisco Remote PHY Shelf 7200
30
and
Step 6, on page 30
for each terminal block connection.
Installing the Cisco Remote PHY Shelf 7200

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Remote PHY Shelf 7200 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents