Cisco Remote PHY Shelf 7200 Installing page 32

Installing the Cisco Remote PHY Shelf 7200
Installing the RPDs
Figure 9: Installing the connector into the PIC connector latches
2. Gently wiggle and push the connector into the panel port hole.
3. The latch will snap closed when the connector is fully seated.
Installing the RPDs
There are 13 RPD slots in the front of chassis on a 1.26" pitch (12+1).
Note
The connectors overhang the rear of the board. Handle the Line Cards with care so as to avoid damage to the
RF and digital connectors on the rear of the card.
To install the RPD, complete the steps:
1. Align the rear carrier guide edges on the RPD to the yellow carrier guides in the chassis.
Installing the Cisco Remote PHY Shelf 7200
32