Cisco Remote PHY Shelf 7200 Installing page 4

Attaching the Chassis Rack-Mount Brackets
• Front Rack-Mounting the system: The chassis is shipped with the rack-mount brackets installed in the
• Mid Rack-Mounting the system: Install the mounting bracket in the middle of the chassis, so that you
To install the rack-mount brackets in the middle of the chassis, complete the following steps:
Before you begin
Required Tools and Equipment
• #2 Phillips torque screwdriver
Step 1
Remove the rack-mount brackets installed in the front of the chassis by unscrewing the M5 undercut flat-head screws
using a #2 Phillips screwdriver.
Step 2
Locate the threaded holes at the middle on the side of the chassis that align with the holes in the rack-mount bracket.
Figure 3: Installing Rack-Mount Brackets in the front position
Step 3 Install the 8 M5 undercut flat-head screws to secure each rack-mounting bracket to the chassis.
The bottom two holes on the rack-mount bracket in the power tray area are unused.
Note
Installing the Cisco Remote PHY Shelf 7200
4
front. Proceed to Installing the Cisco Remote PHY Shelf 7200 in a Rack, on page
can recess the chassis in the rack or install the chassis in a two-post rack unit.
Installing the Cisco Remote PHY Shelf 7200
5.