Siemens SINUMERIK 840D sl Function Manual page 1192

Detailed description
2.12 Block descriptions
Warning
If several block calls (FC 15, FC 16, FC 18) are programmed for the same axis/spindle in the
PLC user program, then the functions concerned must be interlocked by conditional calls in
the user program.
The conditional call of a started block (parameter Start or Stop = TRUE) must be called
cyclically until the signal state of output parameter "Active" or "InPos" changes from 1 to 0.
Error identifiers
If a function could not be executed, this is indicated by the "Error" status parameter being set
to 'logical 1'. The error cause is coded at block output "State".
For listing of error identifiers see table in the chapter Block description,
"FC 18: SpinCtrl Spindle control".
Declaration of the function
FUNCTION FC 15: VOID
VAR_INPUT
END_VAR
VAR_OUTPUT
END_VAR
208
Start:
AxisNo:
IC:
Inch:
HWheelOv:
Pos:
FRate:
InPos:
Active:
StartErr:
Error :
//POS_AX
BOOL ;
INT ;
BOOL ;
BOOL ;
BOOL ;
REAL;
REAL;
BOOL ;
BOOL ;
BOOL ;
BOOL ;
Basic logic functions: PLC Basic program powerline (P3 pl)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0