Fuel System - Husqvarna R 214C Workshop Manual

9.3.5 To remove and install the microswitch for the
lift lever
1. Remove the right footrest plate and the right fender.
To remove the covers on page 19
Refer to
2. Disconnect the connector from the microswitch.
3. Remove the microswitch.
4. Install in opposite sequence.
9.3.6 To disassemble and assemble the ignition
switch
1. Remove the side cover on the control panel.
2. Remove the ignition key.
3. Remove the plastic nut and pull down the ignition
switch.
4. Pull the connector to disconnect it from the ignition
switch.
5. Assemble in opposite sequence. Make sure that the
connector goes into the correct position.
30 - Repair instructions

9.4 Fuel system

9.4.1 To replace the fuel filter
1. Open the engine cover to get access to the fuel
filter.
2. Compress the fuel tank hose to prevent leakage.
3. Move the hose clips away from the fuel filter with a
pair of flat pliers.
4. Pull off the fuel filter from the hose ends. A small
quantity of fuel can leak.
5. Push the new fuel filter into the ends of the hoses.
Apply liquid detergent to the ends of the fuel filter to
make the connection easier.
6. Push the hose clips against the fuel filter.
9.4.2 To remove the fuel tank
WARNING: Gasoline is very flammable and
dangerous for the environment. Make sure to
prevent fire and spill.
1. Remove the fender above the fuel tank. See
remove the covers on page 19
2. Put a container below the fuel tank to collect the
gasoline. For information about fuel tank capacity,
Technical data on page 49
see
3. Compress the fuel tank hose to prevent leakage.
4. Disconnect the fuel tank hose from the lower
connection of the fuel filter.
5. Pull the hose through the frame.
To
1592 - 002 - 11.02.2021