Cardinal 205 Installation And Technical Manual page 51

SETUP AND CALIBRATION, CONT.
bAUd2= (Serial Port 2 Baud Rate)
Press the TARE/ENTER key to show the current value. If the setting displayed is acceptable,
press the TARE/ENTER` key again to save it. Otherwise, use the /UP ARROW key to
toggle to a new setting and then press the TARE/ENTER key to save it. Allowable values are:
12 = 1200 Baud
96 = 9600 Baud
28 = 28.8k Baud
76 = 76.8k Baud
Prty2= (Serial Port 2 Parity)
Press the TARE/ENTER key to show the current value. If the setting displayed is acceptable,
press the TARE/ENTER` key again to save it. Otherwise, use the /UP ARROW key to
toggle to a new setting and then press the TARE/ENTER key to save it. Allowable values are:
0 = NONE (No Parity)
bitS2= (Serial Port 2 Data Bits)
Press the TARE/ENTER key to show the current value. If the setting displayed is acceptable,
press the TARE/ENTER` key again to save it. Otherwise, use the /UP ARROW key to
toggle to a new setting and then press the TARE/ENTER key to save it. Allowable values are:
7 = 7 Data Bits
StoP2= (Serial Port 2 Stop Bits)
Press the TARE/ENTER key to show the current value. If the setting displayed is acceptable,
press the TARE/ENTER` key again to save it. Otherwise, use the /UP ARROW key to
toggle to a new setting and then press the TARE/ENTER key to save it. Allowable values are:
1 = 1 Stop Bit
Cont2= (Continuous Output Serial Port 2)
Press the TARE/ENTER key to show the current value. If the setting displayed is acceptable,
press the TARE/ENTER` key again to save it. Otherwise, use the /UP ARROW key to
toggle to a new setting and then press the TARE/ENTER key to save it.
Cont2= YES
Continuous Output
If Cont2= YES (Continuous Output) is selected, an additional prompt, tYPE2=
will be displayed.
If Cont2= no (No Continuous Output) is selected, proceed to the Weight On
Demand section.
tyPE2= (Continuous 2 Output Format)
Press the TARE/ENTER key to show the current value. If the setting displayed is acceptable,
press the TARE/ENTER` key again to save it. Otherwise, use the /UP ARROW key to
toggle to a new setting and then press the TARE/ENTER key to save it. Allowable values are:
0 = SMA
3 = Rice Lake IQ355
6 = Number Only
9 = Ranger 5000 Format A
If tYPE2=7 (Toledo Long/Short) is selected, an additional prompt, tShort will
be displayed.
8200-M129-O1 Rev D  205 Installation & Technical
24 = 2400 Baud
14 = 14.4k Baud
38 = 38.4k Baud
11 = 115.2k Baud
1 = Odd Parity
8 = 8 Data Bits
2 = 2 Stop Bits
Cont2= no
No Continuous Output
1 = SB-400
4 = AnDFV
7 = Toledo Long/Short
48 = 4800 Baud
19 = 19.2k Baud
57 = 57.6k Baud
23 = 230.4k Baud
2 = Even Parity
2 = SB-200
5 = WI110
8 = SB500 with Traffic Light
45