Cardinal 205 Installation And Technical Manual page 40

SETUP AND CALIBRATION, CONT.
Dual-Point with Zero (First Zero) Calibration
IMPORTANT! The functions of numeric keys are replaced by using the UNITS/LEFT
ARROW and the /UP ARROW keys. The cursor location is identified by the
blinking character and can be advanced to the left to the next position by pressing
the UNITS/LEFT ARROW key. Pressing the /UP ARROW key will change the
blinking character to the next value.
CAL1= – First Calibration Weight
The display will show CAL1=0. This is the first of two calibration weights. This weight
could be ZERO (NO LOAD) or the TEST WEIGHTS / TEST LOAD.
• If the first calibration weight is to be ZERO (NO LOAD), press the TARE/ENTER key.
• If the first calibration weight is to be the TEST WEIGHTS / TEST LOAD, use the
UNITS/LEFT ARROW and the /UP ARROW keys to input the value of the calibrated
test weights. NOTE! When entering values for CAL1=, the digits start displaying on
the right side of the display and proceed to the left. When large values are used (more
than 3 digits), the CAL1= prompt will automatically scroll off the left side of the display
to show the additional digits on the right as they are entered.
• Place the weights on the scale platform, then press the TARE/ENTER key.
• Starting at the left and advancing right, a series of dashes will appear on the display.
The dashes will stay on the display momentarily, then disappear, after which the display
will show: CAL2=.
CAL2= - Second Calibration Weight
The display will show CAL2=0. This is the second of two calibration weights. This
weight could be ZERO (NO LOAD) or the TEST WEIGHTS / TEST LOAD.
• If the second calibration weight is to be ZERO (NO LOAD), press the TARE/ENTER key.
• If the second calibration weight is to be the TEST WEIGHTS / TEST LOAD, use the
UNITS/LEFT ARROW and the /UP ARROW keys to input the value of the calibrated
test weights. NOTE! When entering values for CAL2=, the digits start displaying on
the right side of the display and proceed to the left. When large values are used (more
than 3 digits), the CAL2= prompt will automatically scroll off the left side of the display
to show the additional digits on the right as they are entered.
• Place the weights on the scale platform, then press the TARE/ENTER key.
• Starting at the left and advancing right, a series of dashes will appear on the display.
The dashes will stay on the display momentarily, then disappear, after which the display
will show: Sio?.
8200-M129-O1 Rev D  205 Installation & Technical
34